Euromix™ AAC Adhesive
Euromix™ AAC Adhesive is specially formulated for bonding aerated autoclaved concrete (AAC) lightweight panels and blocks.
Mixing The Adhesive
1. Add approximately 5L of clean potable water to a clean plastic bucket.
2. Gradually add 20kg of Euromix™ AAC Adhesive to the water whilst mixing on low speed with an electric paddle mixer to disperse the powder into a creamy, lump free consistency.
3. Allow the mix to stand for 3-5 minutes prior to use.
4. Do not remix or add any additives to the mix.
5. Do not reuse any spilled material.
Application
- Follow the manufacturer’s specifications and instructions for installing the AAC.
- Apply the Euromix™ AAC Adhesive to the horizontal and vertical surfaces of the AAC panel or block with a 6 - 12mm notched trowel.
- Apply the Euromix™ AAC Adhesive to a maximum of 6 blocks or 1 panel at one time.
- Position the AAC panels or blocks by gently using a rubber mallet to secure them into position. Use a spirit level to check the level and alignment of blocks.
- The thickness of the Euromix™ AAC Adhesive joint should be approximately 2-3mm.
- The mixed material is useable for up to 5 hours @ 25°C and 50% relative humidity.
Drying Time
The Euromix™ AAC Adhesive will cure after 24 hours at 25°C after which it can be over coated with Euromix™ Renders. Do not apply in temperatures below 10°C or above 35°C. Application in conditions below 10°C will extend the drying time whilst application in conditions above 35°C will shorten the drying time and premature curing of the adhesive could result in the adhesive not reaching a full bond.
Coverage
Coverage will vary depending on the condition of the surface and site conditions. As a guide, 20kg of Euromix™ AAC Adhesive will fix 25m2 of 75mm AAC panel.
Warranty
The product use information on this bag is provided in good faith and the product is sold on the basis that it is used for its intended purpose and is applied in a proper workmanlike manner in accordance with the instructions of the relevant Euromix™ recommendations in suitable and safe working conditions. Under no circumstances will Euromix™ be liable for loss, consequential or otherwise, arising from the misuse of the product.
Euromix™ will replace any material that is found to be of faulty manufacture or unsuitable for use as detailed in Euromix™ literature. This Warranty is provided in lieu of all other warranties, whether expressed or implied, and all other obligations on the part of Euromix™ apart from any warranties or conditions which arise by operation of law and which may not be negated or modified.
©2021 Euromix. All rights reserved | Terms of Service | Privacy Policy